Gasboy 9800A Uživatelský manuál stáhnout pdf (Strana 8)

Installation of the 9800A/2600A Pump Interface Kit

Page 8 MDE-4863 Gasboy® 9800A or 2600A Pump Interface Kits Installation Instructions · October 2009

9 Feed the DC Cable up through the platform bushing. The DC Cable is a 4-conductor Gray

Cable with red, green, white, and black wires terminated to a 5-position connector; it is part of

the DC Conduit Assembly. Attach the DC Cable to P1 of the Pump I/F PCB (P1 is a 4-pin

connector). Ensure that you align Pin 1 of the Cable Connector with Pin 1 of the P1 Connector.

If present, Pin 5 of the Cable Connector is not used and will hang off to the end of the P1

Connector.

Figure 6: Platform Assembly

Platform

Bushing

10 Connect the wiring between the Card System and DC Junction Box as shown in MDE-4341

Series 9800A/9800Q Pump and Dispenser Installation/Operation Manual.

11 Secure the Display Panel in the upright position.

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

Gasboy 9800A Uživatelský manuál Strana 8