Gasboy 9800A Uživatelský manuál stáhnout pdf (Strana 9)

MDE-4863 Gasboy® 9800A or 2600A Pump Interface Kits Installation Instructions · October 2009 Page 9

Pulse-out I/F Board (M06587A001) Jumper Settings

12 Attach the Bezel. Ensure that the Bezel is seated properly to ensure a watertight seal.

13 Attach and lock the front panel.

14 Turn on the Circuit Breakers.

Pulse-out I/F Board (M06587A001) Jumper Settings

Jumpers JP1, JP2, and JP3

This Board Assembly can be configured for use in one of the following pump/dispenser

configurations:

• Single-channel, Dual/Single-hose Pulse-out I/F (see Figure 7 on page 10)

• Dual-channel, Single-hose Pulse-out I/F (see Figure 8 on page 11)

The chart below shows the jumper settings and wires to connect to in the Junction Box, based

on the configuration.

Check JP1 - JP3 jumpers and change them, if necessary. The jumper settings must be changed

only when the power to the pump/dispenser is removed, to protect the circuit that they are

connected to.

For models 9800A, 2600A, or 9800Q, the P3 connector is not connected.

Jumper Settings

Single-channel,

Dual/Single-hose Pulse-out I/F

(Default Setting)

Dual-channel,

Single-hose Pulse-out I/F

(C07357 kits)

Wire Color JP1 Position 1

JP2 Position 1

JP3 Open

JP1 Position 2

JP2 Position 2

JP3 Open

Red Pulse-out Side 1 Pulse-out Side1A

Green Pulse-out Side 2 Pulse-out Side1B

White Common Return Side 1A Return

Black No Connection Side 1B Return

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

Gasboy 9800A Uživatelský manuál Strana 9