Gasboy 9800A Uživatelský manuál stáhnout pdf

032093 Rev. 7261 Page 1

TOTALIZER/PULSER/GEAR TRAIN ASSEMBLY RETROFIT KIT

FOR 9850A, 9850AX, 9850AXTW, 2650A, 2650AX, 2650AXTW UNITS (See NOTE)

This instruction sheet shows how to install the totalizer/pulser/gear train assembly kit for Series 9850A/2650A

pumps and dispensers. The available kits are listed below. Refer to the table to determine the contents for each

kit. Be sure to follow all warnings and safeguards as outlined in the enclosed Warnings and Safeguards sheet

before working on the unit.

NOTE: If your pump/dispenser is a 9850A, 9850AX, 9850AXTW, with a serial number higher than 472238 or

a 2650A, 2650AX, 2650AXTW with a serial number higher than 0009491-T, you do not need this kit.

Instead, just order the Totalizer kit for your model as listed in the 9800A Parts List, 035297 or 2600A

Parts List, T35297. The serial number appears on the UL nameplate on the side of the unit.

KIT SUMMARY

032094 Model 9850A, 2650A, Liter

032095 Model 9850A, 2650A, Gallon

032096 Model 9850AXTW, 2650AXTW, Liter

032097 Model 9850AXTW, 2650AXTW, Gallon

032098 Model 9850AX, 2650AX, Liter

032099 Model 9850AX, 2650AX, Gallon

KIT CONTENTS

1 2 3 4

032093 Rev. 7261 Page 1TOTALIZER/PULSER/GEAR TRAIN ASSEMBLY RETROFIT KITFOR 9850A, 9850AX, 9850AXTW, 2650A, 2650AX, 2650AXTW UNITS (See NOTE)This in

032093 Rev. 7261 Page 21. Remove front and rear doors to gain access to the interior ofthe pump.2. Remove front and rear bezel by removing two screw

032093 Rev. 7261 Page 3Install Totalizer10. Remove existing hardware from totalizer window on side of unit. Setaside for later use or replace.11. I

032093 Rev. 7261 Page 417. On the LCD Display PCB, set the K2, K4, and K6 decimal point jumpers to hundredths as shown below. Thedisplays will sho

Další dokumenty pro Hardware Gasboy 9800A

Žádné komentáře